Cp-electronics MWS3A-PRM Manual do Utilizador

page 1. Dimensions Section Contents Page 1 Dimensional information 1 2 Description and operation 2 3 Wiring & Installation 3 4 Fixin

page 2 The MWS3A-PRM (microwave) detector provides automatic control of lighting loads with optional manual control. It can be used on incandescent,

page 3 3. Wiring & Installation 1. Wire the products using the diagram opposite. 2. To switch from more than one position simply wire two or

page 4 4. Fixing - Flush 5. Fixing - Surface Warning - be careful bending springs when mounting unit. Warning - be careful bending springs when mou

page 5  Slide open window. 6. Head Locking 7. Time, Lux & Sensitivity Adjusters 1 2  Remove metal locking clip from rear of unit. 1 2 S

page 6 8. Programming All the following functions can be programmed using the remote control DD-LCDHS handset: 1. Detector Parameters (factory d

page 7 9. Detection Patterns 10. Fault Finding LOAD DOES NOT COME ON  Check to see if the live supply to the circuit is good. Strap across the L

page 8 LOAD 10A of lighting and or ventilation including incandescent, fluorescent, compact fluorescent, low voltage (switch primary of transformer).