Cp-electronics VITP-IR Manual do Utilizador

Section Contents Page 1 Dimensional information 1 2 Description and operation 2 3 Fixing and wiring 3 4 Programming 6 5 Detection patter

10 User menu functions with dimming applications Using the Programming Handset (Part No. DD-LCDHS) 4. Press and hold the left arrow key. On the main

11 LIGHTS DO NOT COME ON  Check to see if the Vitesse Plus marshalling box is powered up and the wiring is correct. Disconnect both RJ45 connectio

12 Ref #WD157 Issue 5 LOAD See datasheet for VitessePlus marshalling box SUPPLY VOLTAGE 12VDC TIME OUT PERIOD Adjustable 10 seconds to 99 minu

2 The VITP-PD/IR presence detector switches are designed to provide automatic control of lighting loads via the VitessePlus marshalling box. They d

3 1. Connect a Cat 5 (RJ45) patch lead from the back of the sensor to the relevant port on the VitessePlus marshalling box. An additional RJ45 conn

4 3. Fixing & Wiring (continued) 2 x VitessePlus RJ45 Connections for Cat 5 patch leads When mounting the detector:-  Avoid direct sunlight e

5 Surface Mount Backing Box (Part No. DBB) (not supplied with detector) 3 4 3 4 5 6

6 USING AS A DIMMER  When the lighting is switched, the light level can be manually adjusted on a temporary basis. Set the level using the LUX UP

7 4. Programming (continued) Using the Programming Handset (Part No. DD-LCDHS) All the following functions can be programmed using the remote contro

8 4. Programming (continued) 2. Press and hold the left arrow key. On the main menu (―Detector Param‖ will be showing), scroll right until the ―Ch1(

9 3. Press and hold the left arrow key. On the main menu (―Detector Param‖ will be showing), scroll right until the ―Ch2(dim) Set‖ menu appears on t